Refrigerant Lines, Disconnecting And Connecting At Condenser: Installing

WARNING: This page is about a different variant/trim than selected.

The installation takes place in reverse order and is identical for both versions and at the same time note the following:

Coat the O-ring seals lightly with refrigerant oil before installing. Refer to REFRIGERANT CIRCUIT SEALS .
Install the refrigerant lines stress-free.

-- Clean the refrigerant line connections on the condenser and on the refrigerant lines and check for damage.

-- Check the alignment pin (installed in the condenser connection or the refrigerant line, not present in all connections) for damage and correct seating.

-- Check the routing of the refrigerant lines after attachment. They must be inserted in the provided brackets in a tension-free manner and must not come in contact with other components.

-- Evacuate and charge the refrigerant circuit. Refer to Refrigerant Circuit (R134a) or Working with A/C Service Station (R1234yf) (1 of 2) or Working with A/C Service Station (R1234yf) (2 of 2) .

-- Start the A/C system after charging the refrigerant circuit. Refer to A/C SYSTEM, STARTING AFTER CHARGING REFRIGERANT CIRCUIT .