Evacuating And Charging Valve, Removing And Installing, Low And High Pressure Side: Installing
WARNING: This page is about a different variant/trim than selected.
Install in reverse order of removal and note the following:
- Depending on the refrigerant, the evacuating and charging valves may vary. Refer to Parts Information.
-- Check the securing of the refrigerant lines to the service connections in the bracket -E-.
-- Evacuate and charge the refrigerant circuit. Refer to Refrigerant Circuit (R134a) or Working with A/C Service Station (R1234yf) (1 of 2) or Working with A/C Service Station (R1234yf) (2 of 2) .
-- Start the A/C system after charging the refrigerant circuit. Refer to A/C SYSTEM, STARTING AFTER CHARGING REFRIGERANT CIRCUIT .