Rear A/C Display Control Head -E265-, REMOVING AND INSTALLING, "High" A/C SYSTEM, Q5: Removing
WARNING: This page is about a different variant/trim than selected.
-- Switch off the ignition.
-- Remove the rear center console vent -A-. Refer to OVERVIEW - CENTER CONSOLE .
-- Loosen the clamp -E- from the Rear A/C Display Control Head -E265-.
-- Pry out the Rear A/C Display Control Head -E265- from the rear center console -A- -arrow-.
-- Disconnect the connectors -C- and if equipped connector -D- from the Rear A/C Display Control Head -E265- -B-.