BELT PULLEY (WITHOUT A/C Clutch -N25-), REMOVING AND INSTALLING, A/C COMPRESSOR "Denso" MANUFACTURER VERSION "2": Notes

WARNING: This page is about a different variant/trim than selected.

Information about replacing the belt pulley. Refer to OVERVIEW - A/C COMPRESSOR BELT PULLEY, "Denso" VERSION "2" .

Fig 1: Identifying Drive Plate, Belt Pulley, And Circlip
Courtesy of AUDI OF AMERICA, LLC
The belt pulley is made of plastic and is sensitive to impact, therefore be especially careful when handling it.
If the drive plate overload protection -C- has triggered, the drive plate can be pried off of the belt pulley -D- after removing the circlip -A-
To optimize noise reduction, a circlip -A- with a vulcanized rubber disc is installed. Refer to OVERVIEW - A/C COMPRESSOR BELT PULLEY, "Denso" VERSION "2" and the Parts Information.