Telephone Baseplate -R126-, REMOVING AND INSTALLING: Removing
WARNING: This page is about a different variant/trim than selected.
-- Turn off the ignition and all electrical equipment and remove the ignition key.
The Telephone Baseplate -R126- -1- is clipped into the storage compartment.
-- Using the : T40388 -A-, carefully push the rubber lip on the Mobile Device Charger 1 -J1146- to the side and guide in the : T40388 as shown.
-- The catch -2- is released and engages in the groove on the : T40388 -A-.
-- Use the : T40388 to remove the Mobile Device Charger 1 -J1146- -1- from the storage compartment.
-- Release and disconnect the connectors from the Mobile Device Charger 1 -J1146-.