Left And Right Front Treble Speaker 2 -R220- / -R221-, Removing And Installing: Removing
WARNING: This page is about a different variant/trim than selected.
-- Turn off the ignition and all electrical equipment and remove the ignition key.
-- Remove the A-pillar trim panel. Refer to A-PILLAR TRIM PANEL, REMOVING AND INSTALLING .
-- Release and disconnect the connector from the Left Front Treble Speaker 2 -R220- -1-.
-- Remove the rivet -arrow- with a suitable drill bit.
-- Remove the Left Front Treble Speaker 2 -R220- -1-.
CAUTION:
Always remove any shavings resulting from the drilling otherwise they may cause corrosion damage later.
If the paint on the door frame gets damaged during drilling, touch-up immediately.