Component Location Overview - Peripheral Camera
WARNING: This page is about a different variant/trim than selected.
NOTE:
The component locations are shown on a Coupe. The component locations for the other vehicle models are the same.
- Right Peripheral Camera -R245- /Left Peripheral Camera -R244-
- Bracket screws: 2 Nm
- Removing and Installing. Refer to RIGHT AND LEFT PERIPHERAL CAMERAS -R244- / -R245-, REMOVING AND INSTALLING .
- Calibrating. Refer to PERIPHERAL CAMERA, CALIBRATING .
- Rear Peripheral Camera -R246-
- Cabriolet bracket bolt/nut: 4 Nm
- Calibrating. Refer to PERIPHERAL CAMERA, CALIBRATING .
- Removing and Installing, Coupe/Sportback. Refer to Rear Peripheral Camera -R246-, REMOVING AND INSTALLING .
- Removing and Installing, Cabriolet. Refer to Rear Peripheral Camera -R246-, REMOVING AND INSTALLING, CABRIOLET .
- Peripheral Camera Control Module -J928-
- Calibrating. Refer to PERIPHERAL CAMERA, CALIBRATING .
- Behind the left luggage compartment side trim panel
- The appropriate Wiring Diagram
- Removing and Installing. Refer to Peripheral Camera Control Module -J928-, REMOVING AND INSTALLING .
- Front Peripheral Camera -R243-
- Bolts: 3 Nm
- Calibrating. Refer to PERIPHERAL CAMERA, CALIBRATING .
- Removing and Installing. Refer to Front Peripheral Camera -R243-, REMOVING AND INSTALLING .