Emergency Call Module Antenna 2 -R322-, REMOVING AND INSTALLING, CABRIOLET, THROUGH MY 2018 AND FROM MY 2019, WITHOUT CONNECT PLUS (IV0): Removing
WARNING: This page is about a different variant/trim than selected.
-- Turn off the ignition and all electrical equipment and remove the ignition key.
-- Remove the rear seat backrest. Refer to REAR SEAT BACKREST, REMOVING AND INSTALLING .
The Emergency Call Module Antenna 2 -R322- is clipped into the bracket of the Data Bus on Board Diagnostic Interface -J533-.
-- Unclip the Emergency Call Module Antenna 2 -R322- -2- from the bracket -1-.
-- Release and disconnect the connector -3-.