Antenna Amplifier 2 -R111-, REMOVING AND INSTALLING, SPORTBACK: Removing
WARNING: This page is about a different variant/trim than selected.
-- Turn off the ignition and all electrical equipment and remove the ignition key.
-- Remove the rear lid upper trim panel. Refer to REAR LID UPPER TRIM PANEL, REMOVING AND INSTALLING .
-- Release and disconnect the connectors -2- and -5- from the Antenna Amplifier 2 -R111- -1-.
-- Remove the screw -3- and remove the Antenna Amplifier 2 -R111- -1- from the rear lid -4-.