Exhaust Gas Temperature Sensor 3 -G495-, REMOVING AND INSTALLING: Removing
WARNING: This page is about a different car, the 2020 Audi A5 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
-- Remove the plenum chamber bulkhead. Refer to PLENUM CHAMBER BULKHEAD, REMOVING AND INSTALLING .
-- Remove the engine cover. Refer to ENGINE COVER, REMOVING AND INSTALLING .
-- Disconnect the connector -2- and free up the wire.
-- Remove the Exhaust Gas Temperature Sensor 3 -G495- -1-.