Accelerator Pedal Position Sensors -G79- / -G185-, Removing And Installing: Installing
WARNING: This page is about a different car, the 2022 Audi S5, 2021 Audi S5, 2020 Audi S5, and 2020 Audi A5 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
Install in reverse order of removal and note the following:
-- Engage the accelerator pedal module on the bottom of the pedal bracket, insert the centering pin and tighten the bolt.
NOTE:
Depending on the engine/transmission combination, an adaptation must be performed after replacing.
If a corresponding menu item is in the engine electronics tree structure under "functions", perform the adaptation using the Vehicle Diagnostic Tester.