LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2022 >> A5 Quattro Prestige, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 90 (Cooling System [CYMC,CYRB,CYRC,CWPB,DDWA,DKNA,DKWA,DLHB,DDWB]) >> 19 Cooling System >> Coolant Pump/Coolant Thermostat >> Coolant Valves, Removing And Installing >> Transmission Coolant Valve -N488-, REMOVING AND INSTALLING >> Removing

Transmission Coolant Valve -N488-, REMOVING AND INSTALLING: Removing

WARNING: This page is about a different car, the 2020 Audi A5 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

-- Remove the rear noise insulation. Refer to NOISE INSULATION, REMOVING AND INSTALLING .

-- Disconnect the connector -2-.

Fig 1: Transmission Coolant Valve -N488- Component Location
GWWA19-11641Courtesy of AUDI OF AMERICA, LLC

-- Loosen the hose clamps -1-, then clamp off the coolant hoses with the : 3094  and then remove them.

-- Remove the nuts -arrows- and then remove the Transmission Coolant Valve -N488-.

scientia non olet · About LEMON Manuals