Left Coolant Pipe, Removing And Installing, 2.9L Engine: Removing

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2022 Audi S5, 2022 Audi RS 5 Sportback, 2022 Audi RS 5, 2021 Audi S5, and 2021 Audi RS 5 Sportback. However, it is still accessible from the selected car via links, so may be relevant.

-- Support the engine in the installation position (refer to ENGINE, SUPPORTING IN INSTALLATION POSITION ) and pretension it with the :10-222A/11 until the pressure on the left engine mount is released.

-- Remove the noise insulation. Refer to NOISE INSULATION, REMOVING AND INSTALLING .

-- Place the container of the :VAS5014 or :VAS6208 underneath.

-- Clamp off the coolant hose -3- using the :3094 .

Courtesy of AUDI OF AMERICA, LLC

-- Loosen the hose clamp -1-, then clamp off the coolant hose with the :3094 and remove the hose.

-- Loosen the hose clamp -2- and remove the coolant hose.

-- Remove the nuts -arrows- and remove the coolant pipe toward the front to do so slightly lift the engine.