Diagnostic Procedures, Performing

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2022 Audi S5 Sportback, 2022 Audi RS 5 Sportback, 2022 Audi A5 Sportback, 2021 Audi S5 Sportback, and 2021 Audi RS 5 Sportback. However, it is still accessible from the selected car via links, so may be relevant.

Procedure:

-- Connect the Vehicle Diagnostic Tester. Refer to VEHICLE DIAGNOSTIC TESTER, CONNECTING .

-- Select Diagnostic mode and start the diagnosis.

-- Perform the vehicle identification.

-- Remove the hooks with Guided Fault Finding procedures .

-- Switch to the Special Functions tab and select the following program:

Entire pre-delivery inspection

-- Start the program using Perform test... .

-- Follow and complete the program sequence.

-- Switch to the Control modules tab and press the Guided Fault Finding button and perform the Guided Fault Finding through to the test plan.

-- Complete the test programs on the fault locations from the DTC memory to be read out.