LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2022 >> A5 Quattro Prestige, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 280 (General Information) >> General Information >> Maintenance Work >> Connected Gateway, Replacing Emergency Battery >> Removing

Connected Gateway, Replacing Emergency Battery: Removing

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2022 Audi S5 Sportback, 2022 Audi RS 5 Sportback, 2022 Audi A5 Sportback, 2021 Audi S5 Sportback, and 2021 Audi RS 5 Sportback. However, it is still accessible from the selected car via links, so may be relevant.

-- Switch off the ignition and all electrical equipment and remove the ignition key.

-- Remove the bench seat. Refer to BENCH SEAT/SINGLE SEAT, REMOVING AND INSTALLING .

The Data Bus on Board Diagnostic Interface -J533- must not be removed.

-- Release the retainers and remove the cover upward from the Data Bus on Board Diagnostic Interface -J533- -1- in the direction of -arrow-.

Fig 1: On Board Diagnostic Interface -J533-
GWWA91-12580Courtesy of AUDI OF AMERICA, LLC

-- Pivot the Telematics Emergency Battery -A16- -1- out of the Data Bus on Board Diagnostic Interface -J533-.

Fig 2: Telematics Emergency Battery -A16-
GWWA91-12581Courtesy of AUDI OF AMERICA, LLC

-- Release and disconnect the connector.