General Information - Name Badges And Emblems, Replacing
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2022 Audi S5 Sportback, 2022 Audi A5 Sportback, 2021 Audi S5 Sportback, 2021 Audi RS 5 Sportback, and 2021 Audi A5 Sportback. However, it is still accessible from the selected car via links, so may be relevant.
Special tools and workshop equipment required
- Roller: 3356
- Cleaning Solution: D 009 401 04
- Loosened name badges and emblems must be replaced.
- The vehicle as well as the name badges and emblems must be at room temperature.
- The adhesive surfaces must be free of dirt and grease.
-- Remove the adhesive residue from the body.
-- Clean the painted side of the adhesive surface with Cleaning Solution: D 009 401 04 and let dry.
-- Warm the adhesive areas to approximately 40 °C (104 F) using a hot air blower.
- Neighboring components must be protected against temperature effects.
-- After successfully assembling, press on the emblems again with the roller.
- Resting time approximately 30 minutes at room temperature