Wheel Covers, Removing And Installing, Front: Installing
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2022 Audi S5 Sportback, 2022 Audi A5 Sportback, 2021 Audi S5 Sportback, 2021 Audi RS 5 Sportback, and 2021 Audi A5 Sportback. However, it is still accessible from the selected car via links, so may be relevant.
Install in reverse order of removal and note the following:
- The vehicle and the cover must be at room temperature.
- The adhesive surfaces must be free of dirt and grease.
-- Remove the adhesive residue from the body.
-- Clean the painted side of the adhesive surface with Cleaning Solution: D 009 401 04 and let dry.
-- Apply Bonding Agent: D 355 205 A2 -1- on the painted side of the adhesive surface -2- using the Applicator: D 009 500 25 -3- and let it dry for ten minutes.
- If the Bonding Agent: D 355 205 A2 dries longer than two hours, then it must be primed again.
-- Fold back the end of the protective film, or attach a pulling aid to the protective film.
-- Use the centering pins -4- to insert the wheel cover -1- into the cut-outs -3- on the fender -2-.
-- Remove the protective film on the pulling aids from the adhesive tape -5-.
-- Push on the wheel cover -1- with the : 3356 .
- Resting time approximately 30 minutes at room temperature