LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2022 >> A5 Quattro Prestige, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 269 (Exterior Equipment) >> 66 Exterior Equipment >> Moldings, Trims, Extensions And Trim Panels >> Side Sill Trim Panel, Removing And Installing >> Side Sill Trim Panel, Removing And Installing, RS 4 >> Removing

Side Sill Trim Panel, Removing And Installing, RS 4: Removing

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2022 Audi S5 Sportback, 2022 Audi A5 Sportback, 2021 Audi S5 Sportback, 2021 Audi RS 5 Sportback, and 2021 Audi A5 Sportback. However, it is still accessible from the selected car via links, so may be relevant.

-- Remove the rear door. Refer to DOOR, REMOVING AND INSTALLING .

-- Loosen the front wheel housing liner at the rear and press it to the side. Refer to OVERVIEW - FRONT WHEEL HOUSING LINER .

-- Release the retainers in direction of -B arrows- and remove the side sill trim panel from the securing strip.

GWWA66-11967Courtesy of AUDI OF AMERICA, LLC

-- Retainers the catches in direction of -A arrows- and remove the lower side sill trim panel from the front fender.

-- Warm up the side sill trim panel -1- using the : VAS1978/14A  in the adhesion area -2- and loosen from the bonding.

GWWA66-12045Courtesy of AUDI OF AMERICA, LLC

-- Push the side sill trim panel upward -B arrows- and pivot in the direction of -arrow A-.

-- Push the rear bracket -1- upward in direction of -arrow A- and pivot on the bottom upward in direction of -arrow B- and remove.

GWWA66-11824Courtesy of AUDI OF AMERICA, LLC