Roof Frame Cover, Removing And Installing, A4 AVANT: Installing
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2022 Audi S5 Sportback, 2022 Audi RS 5 Sportback, 2022 Audi A5 Sportback, 2021 Audi S5 Sportback, and 2021 Audi RS 5 Sportback. However, it is still accessible from the selected car via links, so may be relevant.
Install in reverse order of removal and note the following:
- The vehicle and the roof frame cover must be at room temperature.
- The adhesive surfaces must be free of dirt and grease.
-- Remove the adhesive residue from the body.
-- Clean the painted side of the adhesive surface with Cleaning Solution: D 009 401 04 and let dry.
-- Align the roof frame cover -1- with the centering pin -4- on the body -3-.
-- Remove the protective film from the adhesive tape -2-.
-- Press the roof frame cover on until it audibly engages.
-- Press the roof frame cover on near the adhesive surface.
- Resting time approximately 30 minutes at room temperature