Rear Lid, Removing And Installing, A5 Cabriolet: Installing

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2022 Audi S5 Sportback, 2022 Audi RS 5 Sportback, 2022 Audi A5 Sportback, 2021 Audi S5 Sportback, and 2021 Audi RS 5 Sportback. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal and note the following:

When inserting the grommet into the rear lid, make sure it sits correctly.

-- Adjust the rear lid. Refer to REAR LID, ADJUSTING .

Depending on the equipment version, the following additional work must be performed

-- Calibrate the Rearview Camera -R189-. Refer to Rearview Camera System .

Note the conditions here for a required calibration of the Rearview Camera -R189-.

-- Calibrate the Rear Peripheral Camera -R246-. Refer to PERIPHERAL CAMERA, CALIBRATING .

Note the conditions here for a required calibration of the Rear Peripheral Camera -R246-.

Tightening Specifications

Refer to OVERVIEW - REAR LID, A5 CABRIOLET