Insulation, Removing And Installing: Installing
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2022 Audi S5 Sportback, 2022 Audi RS 5 Sportback, 2022 Audi A5 Sportback, 2021 Audi S5 Sportback, and 2021 Audi RS 5 Sportback. However, it is still accessible from the selected car via links, so may be relevant.
Install in reverse order of removal and note the following:
-- A4 and A5: first slide the insulation over the tabs on the rear edge and into the designated cut-outs on the inner panel -3-.
-- RS 4 and RS 5: push the insulation first over the tabs on the rear edge in the specified cut-out on the inner panel -3- and at the same time push the tabs of the heat shield in the specified cut-out on the insulation.
-- Insert the tabs at the front edge and sides.
-- The clips must engage audibly when pressing in.