Overview - Windshield Projection (Head-Up Display)

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2022 Audi S5 Sportback, 2022 Audi RS 5 Sportback, 2022 Audi A5 Sportback, 2021 Audi S5 Sportback, and 2021 Audi RS 5 Sportback. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Exploded View Of Windshield Projection (Head-Up Display)

Courtesy of AUDI OF AMERICA, LLC

Nut
- 8 Nm
- Quantity: 3
Expanding Rivet
- For air duct
Exterior Bracket
- For windshield projection control module
- Removing and installing. Refer to OUTER BRACKET, REMOVING AND INSTALLING .
Bolt
- Tightening sequence. Refer to Fig 2.
- Replace after removing.
- Quantity: 2
Instrument Panel
Bolt
- 1 Nm
- Quantity: 5
Upper Cover
- Removing and installing. Refer to Windshield Projection Head Up Display Control Module -J898-, REMOVING AND INSTALLING .
Frame
- For upper cover
Air Duct
- For windshield projection control module
Expanding Rivet
- For air duct
Bolt
- Tightening Specifications and Sequence. Refer to Fig 2.
Windshield Projection Head Up Display Control Module -J898-
- Removing and installing. Refer to Windshield Projection Head Up Display Control Module -J898-, REMOVING AND INSTALLING .
- Calibrating. Refer to Windshield Projection Head Up Display Control Module -J898-, CALIBRATING .
Bolt
- Replace after removing.
- Tightening Specifications and Sequence. Refer to Fig 2.
- Quantity: 2
Interior Bracket
- For windshield projection control module
- Removing and installing. Refer to INNER BRACKET, REMOVING AND INSTALLING .
Central Tube
Nut
- 8 Nm
- Quantity: 3

Windshield Projection Head Up Display Control Module - Tightening Specification and Sequence

Fig 2: Windshield Projection Head Up Display Control Module Tightening Sequence

Courtesy of AUDI OF AMERICA, LLC

-- Tighten the bolts in the sequence shown above.

Bolts	Tightening Specification
-1-	5.5 Nm
-2 and 3-	4 Nm