Front Sensor, Removing And Installing: Removing
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2022 Audi S5 Sportback, 2022 Audi A5 Sportback, 2021 Audi S5 Sportback, 2021 Audi RS 5 Sportback, and 2021 Audi A5 Sportback. However, it is still accessible from the selected car via links, so may be relevant.
-- Loosen the wheel housing liner in the front area and push it aside. Refer to FRONT WHEEL HOUSING LINER, REMOVING AND INSTALLING .
-- Press both retainers to the side in direction of -arrows- and at the same time, push the sensor -1- through from the outside toward the inside.
-- Disconnect the connector -2- by sliding the retainer -3- toward the rear and pressing the release down.