Belt Pulley Side Sealing Flange, Removing And Installing, 2.9L Engine: Removing
WARNING: This page is about a different car, the 2022 Audi S5 Sportback, 2021 Audi S5 Sportback, and 2020 Audi S5 Sportback. However, it is still accessible from the selected car via links, so may be relevant.
-- Remove the vibration damper. Refer to VIBRATION DAMPER, REMOVING AND INSTALLING, 2.9L ENGINE .
-- Remove the upper air duct pipe. Refer to AIR DUCT PIPE, REMOVING AND INSTALLING, WITH RADIATOR INSTALLED 2.9L ENGINE .
-- Remove the left front coolant pipe. Refer to LEFT FRONT COOLANT PIPE, REMOVING AND INSTALLING, 2.9L ENGINE .
-- Loosen the hose clamp -arrow- and remove the coolant hose.
-- Disconnect the connector -3- and remove the Cylinder Head Coolant Valve -N489- slightly from the bracket -2-.
-- Disconnect the connector -1-.
-- Remove the bolts -arrows- and remove the bracket from the coolant valve and tie up to the side.
All additional procedures are described. Refer to SEALING FLANGE, REMOVING AND INSTALLING, BELT PULLEY SIDE .