Charge Air Pressure Sensor -G31-, REMOVING AND INSTALLING, 2.9L ENGINE
WARNING: This page is about a different car, the 2022 Audi S5 Sportback, 2022 Audi RS 5 Sportback, 2021 Audi S5 Sportback, 2021 Audi RS 5 Sportback, and 2020 Audi S5 Sportback. However, it is still accessible from the selected car via links, so may be relevant.
Removal - Vehicles with Version 1 Charge Air System:
-- Loosen the hose clamps -1 and 3- and remove the air duct hose.
-- Disconnect the connector -1-.
-- Remove the bolt -2- and the Charge Air Pressure Sensor -G31-.
Removal - Vehicles with Version 2 Charge Air System:
-- Disconnect the connector -1-.
-- Remove the bolt -2- and the Charge Air Pressure Sensor -G31-.
Installing
Install in reverse order of removal and note the following:
- Check the O-ring for damage. Refer to Overview - Charge Air System .
Tightening Specifications
- Refer to Overview - Charge Air System
- Refer to Overview - Charge Air Hose Connections .