Ribbed Belt For Generator, Removing And Installing, 2.9L Engine: Installing

WARNING: This page is about a different car, the 2022 Audi S5 Sportback, 2021 Audi S5 Sportback, and 2020 Audi S5 Sportback. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal and note the following:

-- Install the ribbed belt. Refer to Figure.

-- Pivot the ribbed belt tensioner for the generator using a wrench slightly counter-clockwise in direction of -arrow- and remove the : T10060A .

-- To tension the ribbed belt release the tensioner.

-- Check whether the ribbed belt is routed correctly.

-- Install the A/C compressor ribbed belt. Refer to RIBBED BELT, REMOVING AND INSTALLING .

-- Start the engine and check the ribbed belt routing.

There are different procedures depending on the model. Refer to RIBBED BELT, REMOVING AND INSTALLING .