Part II
WARNING: This page is about a different car, the 2022 Audi S5 Sportback, 2022 Audi RS 5 Sportback, 2021 Audi S5 Sportback, 2021 Audi RS 5 Sportback, and 2020 Audi S5 Sportback. However, it is still accessible from the selected car via links, so may be relevant.
Part I. Refer to Part I .
Part III. Refer to Part III .
- Nut
- 30 Nm
- After loosening, replace the stud bolt. Refer to -item ) List Item: Stud Bolt
- Tensioning Bracket
- Seal
- Replace after removing.
- Stud Bolt
- 15 Nm
- After loosening, replace the nut. Refer to -item ) List Item: Nut
- Tensioning Bracket
- Nut
- 30 Nm
- After loosening, replace the stud bolt. Refer to -item ) List Item: Stud Bolt
- Oil Return Line
- Replace after removing.
- Clip
- Air Duct Pipe
- Bolt
- Tightening specification. Refer to -item ) List Item: Bolt
- Seal
- Replace after removing.
- Air Duct Pipe
- Bolt
- Tightening specification. Refer to -item ) List Item: Bolt
- Seal
- Replace after removing.
- Nut
- Step 1: 15 Nm
- Step 2: 30 Nm
- Step 3: After finishing the procedures, tighten the nuts to 30 Nm
- Replace after removing.
- Turbocharger
- Removing and Installing. Refer to TURBOCHARGER, REMOVING AND INSTALLING, 3.0L ENGINE .
- Screw-Type Clamp
- 20 Nm
- Replace after removing.
- Seal
- Replace after removing.
- Coupling
- If a new turbocharger is installed, replace the coupling
- Nut
- Step 1: 15 Nm
- Step 2: 30 Nm
- Step 3: After finishing the procedures, tighten the nuts to 30 Nm
- Replace after removing.
- Seal
- Replace after removing.
- Stud Bolt
- 15 Nm
- After loosening, replace the nut ) List Item: Nut