Overview - Coolant Pump/Coolant Thermostat
WARNING: This page is about a different car, the 2020 Audi A5 Sportback. However, it is still accessible from the selected car via links, so may be relevant.
- Connection
- O-Ring
- Always replace after removing.
- Coat with coolant
- Centering Pin
- Bolt
- Tightening Specifications and Sequence. Refer to Fig 2.
- Seal
- Always replace after removing.
- Coolant Pump
- Removing and installing. Refer to Coolant Pump, Removing And Installing .
- For a new coolant pump, remove the protective cap
- Bolt
- Tightening sequence. Refer to Fig 3.
- Toothed Belt
- For the coolant pump
- Removing and installing. Refer to Coolant Pump Toothed Belt, Removing And Installing .
- Bolt
- 9 Nm
- Toothed Belt Guard
- Bolt
- 10 Nm + 90°
- Always replace after removing.
- Left-hand thread
- Toothed Belt Sprocket
- Note the installation position
- Seal
- Replacing. Refer to Balance Shaft Gasket, Replacing, Intake Side .
- For the intake side balance shaft
- Intake Side Balance Shaft
- Seal
- Always replace after removing.
- Engine Temperature Control Actuator -N493-
- Removing and installing. Refer to Engine Temperature Control Actuator -N493-, Removing And Installing .
- Perform the adaptation after replacing using the Vehicle Diagnostic Tester
Engine Temperature Control Actuator N493 - Tightening Sequence
-- Tighten the bolts to 9 Nm in the following sequence: -1 to 5-.
Coolant Pump - Tightening Specifications and Sequence
-- Tighten the coolant pump bolts to 9 Nm in a -1 to 4- sequence.