Vacuum Pump, Removing And Installing, 2.0L TFSI Engine: Installing
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2022 Audi S5 Sportback, 2022 Audi RS 5 Sportback, 2022 Audi A5 Sportback, 2021 Audi S5 Sportback, and 2021 Audi RS 5 Sportback. However, it is still accessible from the selected car via links, so may be relevant.
Install in reverse order of removal and note the following:
- Replace the seal after removal.
- Check the vacuum lines for damage before assembling and replace if necessary.
- Secure all hose connections with hose clamps that match the ones used in series production.
-- Turn the vacuum pump yoke -1- so it engages in the groove on the camshaft when positioning the vacuum pump in direction of -arrows-.
-- Install the vacuum hose with the hose clamp -1- connected.
-- Tighten the bolts -arrows-.
-- Install the high pressure pump. Refer to HIGH PRESSURE PUMP, REMOVING AND INSTALLING - CWGD .