Brake Caliper Piston, Removing And Installing, Four-Piston Brake: Installing
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2022 Audi S5 Sportback, 2022 Audi RS 5 Sportback, 2022 Audi A5 Sportback, 2021 Audi S5 Sportback, and 2021 Audi RS 5 Sportback. However, it is still accessible from the selected car via links, so may be relevant.
- Install the entire repair kit.
- Only use mineral spirits to clean the brakes.
- When a brake caliper piston or a piston cylinder are damaged, the brake caliper must be replaced.
-- Clean the surface of the brake caliper piston only with mineral spirits and let it dry.
-- Insert the seal into the brake caliper.
-- Place the protective cap on the brake caliper piston.
-- Without tilting, push the brake caliper piston with inserted protective cap using constant pressure.
-- Insert the Piston Resetting Tool -T10145- and the Thrust Piece:T40325 into the brake caliper.
-- Slowly push the protective cap -1- in using the Piston Resetting Tool -T10145- and Thrust Piece:T40325 .
- The protective cap must fit tightly in the groove. If necessary, push down on it slightly with the Piston Resetting Tool -T10145-.
- The protective cap must no longer be able to be pulled out of the brake caliper by hand.
-- Repeat the work procedure on the next brake caliper piston.