Brake Master Cylinder, Removing And Installing: Removing

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2022 Audi S5 Sportback, 2022 Audi RS 5 Sportback, 2022 Audi A5 Sportback, 2021 Audi S5 Sportback, and 2021 Audi RS 5 Sportback. However, it is still accessible from the selected car via links, so may be relevant.

-- Remove the brake fluid reservoir. Refer to BRAKE FLUID RESERVOIR, REMOVING AND INSTALLING .

-- Remove the left tower brace. Refer to TOWER BRACE, REMOVING AND INSTALLING .

-- Disconnect the connector -3- for the Brake Lamp Switch -F-.

Courtesy of AUDI OF AMERICA, LLC

-- To prevent brake fluid from escaping, place enough lint-free cloths in the area under the brake master cylinder.

CAUTION:

Risk of destroying the brake lines by bending.

- Never change the shape of the brake lines.

-- Remove the union bolts -2- for the brake lines and remove the brake lines from the brake master cylinder.

-- Immediately seal the open connection points with clean plugs from the Engine Bung Set:VAS6122 .

-- Remove the nuts -arrows-.

Do not let anything fall in the brake booster when removing the brake master cylinder.
The actuator pin for the brake lamp switch must not get lost.

-- Disconnect and remove the brake master cylinder from the brake booster.