Starter, Removing And Installing, Vehicles With 6-Cylinder TDI Engine Gen III: Removing

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2022 Audi S5 Sportback, 2022 Audi RS 5 Sportback, 2022 Audi A5 Sportback, 2021 Audi S5 Sportback, and 2021 Audi RS 5 Sportback. However, it is still accessible from the selected car via links, so may be relevant.

-- Disconnect the ground cable from the battery when the ignition is switched off. Refer to Battery -A-, DISCONNECTING AND CONNECTING, 0K4 AND VH2 .

-- Remove the emissions control module. Refer to the appropriate Service Information .

-- Loosen the rear coolant pipes on the transmission and push to the side. Refer to COOLANT PIPES, REMOVING AND INSTALLING [CWGD] or COOLANT PIPES, REMOVING AND INSTALLING [CYMC] .

-- Remove the bolt -arrow-.

Fig 1: Identifying Plenum

Courtesy of AUDI OF AMERICA, LLC

-- Remove the starter generator. Refer to Starter Generator -C29-, REMOVING AND INSTALLING, VEHICLES WITH 3.0L TDI ENGINE GEN III, 0K4 .

-- Remove the right engine support. Refer to ENGINE SUPPORT, REMOVING AND INSTALLING [CWGD] or ENGINE SUPPORT, REMOVING AND INSTALLING [CYMC] .

-- Remove the bolt -5- and nut -4-.

Fig 2: Identifying Starter Overview

Courtesy of AUDI OF AMERICA, LLC

-- Remove the starter -1-, disconnect the connector -3- and free up the B+ wire -2-.