PROTECTIVE HOUSING FOR Battery, 48 V -A6-, REMOVING AND INSTALLING, 0K4 AND VH2: Installing
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2022 Audi S5 Sportback, 2022 Audi RS 5 Sportback, 2022 Audi A5 Sportback, 2021 Audi S5 Sportback, and 2021 Audi RS 5 Sportback. However, it is still accessible from the selected car via links, so may be relevant.
-- Insert the Battery, 48 V -A6- -4- into the protective housing -3-. Pay attention to the dimension -a- to the housing edge -5-.
- Dimension -a- = 2 mm.
-- Tighten the bolts -2- for the retaining bracket -1-.
-- Install the housing cover.
-- Push on the pressure vent tube until it audibly locks. Check the pressure vent tube for secure fit by pulling on it.
Further installation is performed in reverse order of removal, while noting the following:
-- If necessary, adapt the new Battery, 48 V -A6-. Refer to Battery, 48 V -A6-, REMOVING AND INSTALLING, 0K4 AND VH2 .