Outer Rear Three-Point Seat Belt, Removing And Installing, A5 Coupe: Removing
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2022 Audi S5 Sportback, 2022 Audi RS 5 Sportback, 2022 Audi RS 5, 2022 Audi A5 Sportback, and 2021 Audi S5 Sportback. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
Risk of injury due to involuntary deployment.
- Pay attention to the safety precautions when working with pyrotechnic components. Refer to SAFETY PRECAUTIONS WHEN WORKING ON PYROTECHNIC COMPONENTS .
- Observe the disposal regulations for pyrotechnic components. Refer to AIRBAG, BELT TENSIONER AND BATTERY CUT-OUT UNITS, STORING, TRANSPORTING AND DISPOSING (PYROTECHNIC COMPONENTS) .
-- Disconnect the battery ground cable with the ignition turned on. Refer to BATTERY, DISCONNECTING AND CONNECTING .
-- Remove the rear belt end fitting. Refer to OUTER REAR BELT END FITTING, REMOVING AND INSTALLING, A5 COUPE .
-- Remove the rear shelf. Refer to REAR SHELF, REMOVING AND INSTALLING .
-- Remove the noise insulation for the automatic belt retractor.
WARNING:
Risk of injury due to involuntary deployment.
- Before handling pyrotechnic components (for example, disconnecting the connector), the person handling it must "discharge static electricity". For example, this can be done by briefly touching the door striker.
-- Disconnect the connector -3- by releasing the connector lock with a small screwdriver.
-- Loosen the bolt -1- approximately seven turns.
-- Push the three-point seat belt -2- toward the rear in direction of -arrow-, disengage it from the mount and remove it.