Overview - Muffler, Fwd Vehicle: Notes

WARNING: This page is about a different car, the 2020 Audi A5 Sportback. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Exploded View Of Muffler

Courtesy of AUDI OF AMERICA, LLC

Retaining Loop
- Always replace if damaged
- Exhaust System, Installing without Tension. Refer to EXHAUST SYSTEM, INSTALLING WITHOUT TENSION .
Bolt
- 23 Nm
Bracket
Center Muffler
- Original equipment as one unit with the rear muffler. If a repair is required replace each separately
- Separating point. Refer to EXHAUST PIPES/MUFFLERS, DISCONNECTING .
- Exhaust System, Installing without Tension. Refer to EXHAUST SYSTEM, INSTALLING WITHOUT TENSION .
Bolt
- 23 Nm
Bracket
Retaining Loop
- Always replace if damaged
- Exhaust System, Installing without Tension. Refer to EXHAUST SYSTEM, INSTALLING WITHOUT TENSION .
Front Muffler
- With coupling:
  - Do not bend more than 10°
  - Do not load on cable
  - Do not damage wire mesh at decoupling element
- Removing and installing. Refer to FRONT MUFFLER, REMOVING AND INSTALLING .
- Exhaust System, Installing without Tension. Refer to EXHAUST SYSTEM, INSTALLING WITHOUT TENSION .
Gasket
- Always replace after removing.
Nut
- 23 Nm
Mount
- Always replace if damaged
- Check the pretension. Refer to EXHAUST SYSTEM, INSTALLING WITHOUT TENSION .
- Equipped on some models
Bolt
- 23 Nm
Front Clamping Sleeve
- Before tightening, align the exhaust system without tension. Refer to EXHAUST SYSTEM, INSTALLING WITHOUT TENSION .
- Tighten the threaded connections equally to 23 Nm.
- Installation position. Refer to Figure.
Retaining Loop
- Always replace if damaged
- Exhaust System, Installing without Tension. Refer to EXHAUST SYSTEM, INSTALLING WITHOUT TENSION .
Bracket
Bolt
- 23 Nm
Rear Muffler
- Original equipment one unit with the center muffler. If a repair is required replace each separately
- Separating point. Refer to EXHAUST PIPES/MUFFLERS, DISCONNECTING .
- Exhaust System, Installing without Tension. Refer to EXHAUST SYSTEM, INSTALLING WITHOUT TENSION .
Rear Clamping Sleeve
- Before tightening, align the exhaust system without tension. Refer to EXHAUST SYSTEM, INSTALLING WITHOUT TENSION .
- Tighten the threaded connections equally to 23 Nm.
- Installation position. Refer to Figure.