Rain/Light Recognition Sensor -G397-, REPLACING: Installing
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2022 Audi S5 Sportback, 2022 Audi RS 5 Sportback, 2022 Audi A5 Sportback, 2021 Audi S5 Sportback, and 2021 Audi RS 5 Sportback. However, it is still accessible from the selected car via links, so may be relevant.
Install in reverse order of removal and note the following:
CAUTION:
There is a risk of damaging the humidity sensor through improper handling.
-- Gently press the grip surfaces -arrows- on the protective cap -2- together and remove from the sensor -1-.
TIP:
To avoid contaminating the silicone pad, remove the protective cap just before installing it.
-- Insert the sensor -4- into the mount -2-.
- The Rain/Light Recognition Sensor -G397- must not have any embedded objects or bubbles between it and the windshield so that it functions correctly.
-- Press on the clips -1 and 5- until they audibly engage.
-- Connect the connector -3-.
-- After replacing the rain/light recognition sensor it must be coded. Refer to Vehicle Diagnostic Tester.