Overview - Instrument Panel CROSSMEMBER
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2022 Audi S5 Sportback, 2022 Audi RS 5 Sportback, 2022 Audi A5 Sportback, 2021 Audi S5 Sportback, and 2021 Audi RS 5 Sportback. However, it is still accessible from the selected car via links, so may be relevant.
- Bolt
- 20 Nm
- The mounting threads and contact surface must be free of paint, coating and corrosion. The threaded connection serves as the ground connection.
- Quantity: 2
- Threaded Pin
- 20 Nm
- Quantity: 2
- Lifter
- Clipped in the crossmember
- Check the lifter adjusting nut for ease of movement
- Turn the adjusting nut all the way downward until the adjuster engages in the transportation safeguard
- Quantity: 2
- Bolt
- 20 Nm
- Quantity: 2
- Plug
- Quantity: 2
- Pop Rivet Nut with Lifter
- Riveted with the windshield frame
- Check the lifter adjusting nut for ease of movement
- Rotate the adjusting nut all the way down but do not tighten it.
- Quantity: 2
- Bolt
- 20 Nm
- Quantity: 2
- Crossmember
- For the instrument panel
- Removing and Installing. Refer to INSTRUMENT PANEL CROSSMEMBER, REMOVING AND INSTALLING .
- Bolt
- 20 Nm
- Bolt
- 20 Nm
- Quantity: 3
- Bolt
- 3.6 Nm
- For A/C unit
- Quantity: 5
- Nut
- 20 Nm
- Replace after removing.
- Quantity: 2
Tightening Specification - Crossmember/A-Pillar Brace
-- Tighten the bolts/nut in the sequence -A, B and C arrows-.
- Bolt -arrow A- = 8 Nm
- Bolt -arrow B- = 3 Nm
- Nut -arrow C- = 20 Nm
Tightening Specification - Ground Wires on Center Tunnel
-- Nut tightening specification -1-. Refer to the appropriate Wiring Diagram.