Fender, Preparing for Installation
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2022 Audi S5 Sportback, 2022 Audi S5, 2022 Audi RS 5 Sportback, 2022 Audi A5 Sportback, and 2021 Audi S5 Sportback. However, it is still accessible from the selected car via links, so may be relevant.
- The fender can only be ordered in individual components and must be prepared for installation as follows.
Special tools and workshop equipment required
- Pop Rivet Nut Pliers:VAS5072A
- Drill
- Pop rivets. Refer to the Parts Information.
A4/A5:
-- Use pop rivets -1- to fasten the bracket -3- and reinforcement -4- to the fender -2-.
- The brackets must be behind the fender edge.
RS 4 / RS 5:
-- Rivet the adapter -1- on the fender -2- with pop rivets -3-.
- The adapter must be behind the fender edge.
Installing
Install in reverse order of removal and note the following:
-- If equipped, insert the seal -2- into the fender -1-.
Tightening Specifications
- Refer to Overview - Fender