Condenser, Removing And Installing, RS Models: Removing
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2022 Audi S5 Sportback, 2022 Audi RS 5 Sportback, 2022 Audi A5 Sportback, 2021 Audi S5 Sportback, and 2021 Audi RS 5 Sportback. However, it is still accessible from the selected car via links, so may be relevant.
- For all the following work, close the open lines and connections with clean plugs from the Engine Bung Set :VAS6122 .
-- Switch off the ignition.
-- Remove the bumper cover bracket together with the impact member. Refer to OVERVIEW - LOCK CARRIER .
-- Disconnect the refrigerant lines from the condenser. Refer to REFRIGERANT LINES, DISCONNECTING AND CONNECTING AT CONDENSER .
-- Release the catches -arrow- and remove the air duct -1 and 3-.
-- Disconnect the connector -1- for the High Pressure Sensor -G65-.
-- Remove the bolt -2-.
-- Release the left and right catches -arrows-, disengage and remove the condenser on the radiator.