Temperature Control Door Motor -V68-, Removing And Installing: Installing

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2022 Audi S5 Sportback, 2022 Audi RS 5 Sportback, 2022 Audi A5 Sportback, 2021 Audi S5 Sportback, and 2021 Audi RS 5 Sportback. However, it is still accessible from the selected car via links, so may be relevant.

Courtesy of AUDI OF AMERICA, LLC

Install in reverse order of removal and note the following:

CAUTION:

There is a risk of damaging the adjustment motor electronics when turning the mount.

- Turn the adjustment motor mount only when the wiring harness is connected.

- Install the mount carefully and slowly by hand.

The actuator mount does not have a stop. It turns constantly if the actuator is activated. Therefore, it should not be activated when the actuator is removed.
Check the connection between the actuator mount and the shaft; there must not be any play.

-- Check the shaft -A- and the mount -B- for the actuator -C-. They must be properly aligned so that they can be joined.

-- Attach the actuator mount -B- to the door shaft -A-.

-- Connect the connector -C-.

Courtesy of AUDI OF AMERICA, LLC

-- Tighten the bolts -A-.

-- Route the wiring harness to the connector -C- so that it cannot come in contact with any moving parts.

-- Perform a basic setting for the A/C system. Refer to GENERAL INFORMATION AND PROCEDURES - ACTUATORS, REMOVING AND INSTALLING .

Tightening Specification

Refer to OVERVIEW - FRONT ACTUATORS ON "Low" A/C SYSTEM (AND A HEATER WITHOUT AN A/C SYSTEM)