BELT PULLEY (WITHOUT A/C Clutch -N25-), REMOVING AND INSTALLING, A/C COMPRESSOR "Sanden" MANUFACTURER
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2022 Audi S5 Sportback, 2022 Audi RS 5 Sportback, 2022 Audi A5 Sportback, 2021 Audi S5 Sportback, and 2021 Audi RS 5 Sportback. However, it is still accessible from the selected car via links, so may be relevant.
- The belt pulley is made of plastic and is sensitive to impact, therefore be especially careful when handling it.
- If the belt pulley overload protection is triggered, then the A/C compressor must be checked for ease of movement before replacing the belt pulley. If the A/C compressor is difficult to move, this must be replaced completely.
- If the drive plate overload protection was activated, the belt pulley can be rotated using the outer part of the drive plate so that the A/C compressor shaft and the hex fitting on the drive plate (inner part of the drive plate) do not rotate.
-- Remove the ribbed belt. Refer to RIBBED BELT, REMOVING AND INSTALLING [CWGD] / RIBBED BELT, REMOVING AND INSTALLING [CYMC] / RIBBED BELT, REMOVING AND INSTALLING [DPAA] .
-- Belt Pulley, Removing and Installing. Refer to OVERVIEW - BELT PULLEY, "Sanden" A/C COMPRESSOR .