Calibration System: VAS721001, INSTALLING AND ALIGNING: Notes
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2022 Audi S5 Sportback, 2022 Audi RS 5 Sportback, 2022 Audi A5 Sportback, 2021 Audi S5 Sportback, and 2021 Audi RS 5 Sportback. However, it is still accessible from the selected car via links, so may be relevant.
Special tools and workshop equipment required
- Calibration System: VAS721001
- Vehicle Diagnostic Tester
After performing service work on the vehicle, it may be necessary to recalibrate the peripheral camera system. Specifically, this is the case after:
- Replacing one or more cameras
- Peripheral Camera Control Module -J928- replacement
- Software flash from the Peripheral Camera Control Module -J928-
- Record the data set on the Peripheral Camera Control Module -J928-
- Repair work on components in which a camera is installed or that influence the component location of the camera
- Wheel Alignments
- When adjusting the overlap range of the individual cameras
- The standing height of one axle changes by more than 5 mm
- The standing height of the entire vehicle changes by more than 10 mm