Terminal 30 Wire Junction 3 -TV28-, REMOVING AND INSTALLING: Removing
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2022 Audi S5 Sportback, 2022 Audi RS 5 Sportback, 2022 Audi A5 Sportback, 2021 Audi S5 Sportback, and 2021 Audi RS 5 Sportback. However, it is still accessible from the selected car via links, so may be relevant.
-- Disconnect the ground cable from the battery when the ignition is switched off. Refer to Battery -A-, DISCONNECTING AND CONNECTING, 0K2 .
-- Release the retainers in direction of -arrows-.
-- Remove the engine control module -3- and with the lines -1- attached move to the side.
-- Free up the wiring harness -arrows-.
-- Remove the nuts -3 and 4- and the bolts -1-.
-- Remove the engine control module mount -2-.
-- Release the latch in direction of -arrow- and open the cover -1-.
-- Remove the wires -6 and 7- and free them up.
-- Remove the nut -5- and free up the wire -3-.
-- Remove the nuts -2 and 8-.
-- Remove the wire junction -4-.