Terminal 30 Wire Junction -TV2-, REMOVING AND INSTALLING: Removing
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2022 Audi S5 Sportback, 2022 Audi RS 5 Sportback, 2022 Audi A5 Sportback, 2021 Audi S5 Sportback, and 2021 Audi RS 5 Sportback. However, it is still accessible from the selected car via links, so may be relevant.
-- Disconnect the ground cable from the battery when the ignition is switched off. Refer to BATTERY, DISCONNECTING AND CONNECTING .
-- Remove the air filter housing. Refer to AIR FILTER HOUSING, REMOVING AND INSTALLING .
-- Release the retainer in direction of -arrow-.
-- Open the cover -1-.
-- If equipped, remove terminal 30 wire junction 2 and move to the side with the wires still connected. Refer to Terminal 30 Wire Junction 2 -TV22- .
-- Disconnect the connector -5-.
-- Remove the nuts -2 and 3- and free up the wires -1 and 4-.
-- Remove the bolts -arrows-.
-- Remove the wire junction -6-.