LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2022 >> A5 Quattro Prestige, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 189 (Wiring) >> 97 Wiring >> Control Modules >> Data Bus on Board Diagnostic Interface -J533-, REMOVING AND INSTALLING >> Data Bus on Board Diagnostic Interface -J533-, REMOVING AND INSTALLING, COUPE, SPORTBACK >> Removing

Data Bus on Board Diagnostic Interface -J533-, REMOVING AND INSTALLING, COUPE, SPORTBACK: Removing

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2022 Audi S5 Sportback, 2022 Audi RS 5 Sportback, 2022 Audi A5 Sportback, 2021 Audi S5 Sportback, and 2021 Audi RS 5 Sportback. However, it is still accessible from the selected car via links, so may be relevant.

-- Remove the seat cushion. Refer to COVER AND CUSHION, REMOVING AND INSTALLING .

-- Disconnect the connector -1-.

Fig 1: Data Bus On Board Diagnostic Interface -J533
GWWA97-12578Courtesy of AUDI OF AMERICA, LLC

-- If equipped, disconnect the connector -4- and antenna wire -3-.

-- Remove the nuts -arrows-.

-- Remove the data bus on board diagnostic interface -2-.