LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2022 >> A5 Quattro Prestige, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 189 (Wiring) >> 97 Wiring >> Control Modules >> Data Bus on Board Diagnostic Interface -J533-, REMOVING AND INSTALLING >> Data Bus On Board Diagnostic Interface -J533-, REMOVING AND INSTALLING, CABRIOLET >> Removing

Data Bus On Board Diagnostic Interface -J533-, REMOVING AND INSTALLING, CABRIOLET: Removing

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2022 Audi S5 Sportback, 2022 Audi RS 5 Sportback, 2022 Audi A5 Sportback, 2021 Audi S5 Sportback, and 2021 Audi RS 5 Sportback. However, it is still accessible from the selected car via links, so may be relevant.

-- Remove the rear seat backrest. Refer to REAR SEAT BACKREST, REMOVING AND INSTALLING .

-- Remove the expanding clips -3- using the Pliers:T40172C  .

GWWA97-13069Courtesy of AUDI OF AMERICA, LLC

-- Lift the front luggage compartment floor -1- in the data bus on board diagnostic interface area.

-- Disconnect the connectors -6- and antenna wires -2-.

-- Release the retainers in direction of -arrows-.

-- Remove the data bus on board diagnostic interface -4- from the mount -5-.