Reflector, Removing And Installing: Installing
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2022 Audi S5 Sportback, 2022 Audi RS 5 Sportback, 2022 Audi A5 Sportback, 2021 Audi S5 Sportback, and 2021 Audi RS 5 Sportback. However, it is still accessible from the selected car via links, so may be relevant.
- The vehicle and the reflector must be at room temperature.
- The adhesive surfaces must be free of dirt and grease.
-- Clean the plastic side of the adhesive surface with Cleaning Solution: D 009 401 04 and let dry.
-- Apply Plastic Primer: D 366 PR1 A1 on the plastic side of the adhesive surface and let dry until the solvent has completely evaporated.
- Apply the reflector within 60 minutes.
-- Remove the protective films from the adhesive tape -1-.
-- Position the reflector -2- and press it onto the bumper cover -3-.
- Resting time approximately 30 minutes at room temperature