Bumper Cover End Plate, Removing And Installing, RS 4 And RS 5: Removing
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2022 Audi S5 Sportback, 2022 Audi RS 5 Sportback, 2022 Audi A5 Sportback, 2021 Audi S5 Sportback, and 2021 Audi RS 5 Sportback. However, it is still accessible from the selected car via links, so may be relevant.
-- Before product improvement: remove the center air intake grille. Refer to CENTER AIR INTAKE GRILLE, REMOVING AND INSTALLING, A5, RS 4 AND RS 5, BEFORE PRODUCT IMPROVEMENT .
-- From product improvement: remove the wheel spoiler. Refer to FRONT WHEEL SPOILER, REMOVING AND INSTALLING .
-- Free up the wiring harness -2- in direction of -A arrows-.
-- Remove the bolts -4- from the front bumper cover end plate -1-.
-- Pull the bumper cover -5- in the area of the front bumper cover end plate as far as possible in direction of -arrow B- and release the catches -3- in direction of -arrow C-.
-- Remove the front bumper cover end plate toward the rear.