Wheel Bearing Unit, Removing And Installing, Fwd: Removing
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2022 Audi S5 Sportback, 2022 Audi RS 5 Sportback, 2022 Audi A5 Sportback, 2021 Audi S5 Sportback, and 2021 Audi RS 5 Sportback. However, it is still accessible from the selected car via links, so may be relevant.
-- Remove the brake rotor. Refer to FRONT BRAKE ROTOR, REMOVING AND INSTALLING or REAR BRAKE ROTOR, REMOVING AND INSTALLING .
-- Loosen the dust cap from the seat by tapping lightly on claw of the : VW637/2 with the hammer.
-- Press the dust cap off using the : VW637/2 -1-.
CAUTION:
There is a risk of damaging the threads.
- The bolt must not be loosened or tightened with an impact wrench.
-- Remove the bolt -arrow- and remove the wheel bearing unit -1- from the axle stub.
- Handling the wheel bearing. Refer to Figure.
-- Remove the metal washer -2- and front seal -1- from the axle stub -arrow-.