Wheel Bearing Unit, Removing And Installing, Fwd: Installing
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2022 Audi S5 Sportback, 2022 Audi RS 5 Sportback, 2022 Audi A5 Sportback, 2021 Audi S5 Sportback, and 2021 Audi RS 5 Sportback. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Replace the bolt and dust cap after removal.
-- Apply the front seal -1-.
-- Lightly lubricate the metal washer -2- and the axle stub -arrow- with grease. Refer to Parts Information.
-- Carefully slide the wheel bearing unit on the axle stub and do not tilt while doing so.
Further installation is performed in reverse order of removal, while noting the following:
CAUTION:
There is a risk of premature wear on the wheel bearing.
- Use the tools pictured to avoid any moisture entering through a damaged dust cap.
-- Drive in the new dust cap all the way using the : 3241/4 -1-.